Torque Solution Turbo Inlet Hose for WRX/STi 84mm Inlet Turbo (TS-SU-598-NR)

This Torque Solution turbo inlet hose fits 02-07 WRX and 04+ STi with a 3.3" (84mm) inlet turbo. The silicone inlet hose is much larger in size than factory and smooths the air entering the turbo compared to the restrictive OEM corrugated inlet hose. Made from 4-ply high grade silicone and wire reinforced to prevent collapsing under high pressure. Includes a black anodized billet aluminum joiner to connect to a 3" intake.

Vehicle Fitment:
2002-2007 Subaru WRX
2004-2021 Subaru STi
• Also Available Recirculated

Features:
• 84mm / 3.3" Specifically made to fit FP Turbos
• 4 Ply Silicone with Heavy Wire Reinforcement
• Includes Silicone Friendly Stainless Steel Hose Clamps
• Non Recirculated for Vent to Atmosphere (Speed Density)
• Limited Lifetime Warranty

Includes:
(1) 84mm Non Recirc Black Silicone Turbo Inlet Hose
(1) 3" Billet Aluminum Coupler (for 3" Intakes)
(1) 78-101mm Worm Gear Clamp
(1) 70-90mm Worm Gear Clamp
(3) 3/8" 90 Degree Nylon Elbows
(2) 1/2" to 3/8" 90 Degree Nylon Reducer Elbows
(2) 1/2" to 3/8" Straight Nylon Reducer
(2) 5/16" to 3/8" Straight Nylon Reducer
(1) 1/2" Nylon T Fitting
(6) Heavy Duty Zip Ties
(13") 1/2" Fuel/PCV Hose

Install Notes:
It is recommended to use either billet TGV conversions for clearance.

Important Note:
The Torque Solution inlet bypasses the PCV Diagnosis Port. You will need to perform a simple bypass.

1. Locate PCV Diagnosis connector (grey or white depending on year), which located on the block next to throttle body.
2. You will need to use a pair of needle nose pliers to remove the jumper pin inside the PCV Diagnosis connector. This pin should pull out easily only using slight pressure. Do not discard the jumper pin removed from the connector.
3. Place the jumper pin into the female harness plug that was connected to PCV diagnosis connector. Use electrical tape to secure in place.
4. The open port will either be fed into the inlet by using the supplied T fitting and hose by keeping the PCV in place connecting to 1 of the front inlet ports or by connecting to your AOS/Catch can setup by removing the PCV.

See more Torque Solution Products