Radium Catch Can Kit for R35 GTR (20-0555-FL/20-0566-FL)

Radium Engineering catch cans are equipped with large 10AN ORB ports, a 4AN ORB drain port, 2-step oil separation baffling, and an O-ring sealed dipstick. These kits mount using existing factory holes, ensuring seamless integration with surrounding components. Designed as closed-loop systems, they do not vent to atmosphere (VTA), making them both emissions and track legal. These systems effectively remove oil and sludge from PCV gases before they re-enter the engine, promoting negative crankcase pressure for enhanced performance. Closed systems also prevent unwanted oil vapors from entering the cabin. The built-in dipsticks allow for easy inspection of fluid levels, and installation requires no cutting, drilling, or permanent modifications.

Vehicle Fitment:
2009+ Nissan GTR (R35 VR38DETT)
• Install Instructions (PDF)

Dual Catch Can Option:
To retain factory functionality, the two CCV catch cans run inline between each crankcase vent (CCV) port and the corresponding turbo inlets.

At low loads, these catch cans experience atmospheric pressure. However, when the engine is at high load (WOT), these vents will experience high flow out of the crankcase. This would normally lead to oil and sludge accumulation in the air filter intake pipe. Oil accumulation will occur in the intercooler which lowers the thermal efficiency properties of the heat exchanger and leads to decreased performance.

NOTES:

1. he dual CCV catch can kit does NOT address blow-by from the PCV valve side of the crankcase.
2. The dual CCV catch can kit is compatible and recommended to be used with the PCV catch can kit. See 20-0566-FL below.

Triple Catch Can Option:
For the ultimate in engine protection, Radium recommends 20-0566-FL Triple Catch Can Kit, Nissan R35 GT-R.
This kit utilizes both the dual "CCV" and single "PCV" catch can kits detailed above.

NOTE:

1. For RHD vehicles, some modifications may be required for PCV catch can mounting.

Includes:
• Anodized oil catch can(s) with integrated condenser and dipstick(s)
• Anodized aluminum R35 GT-R specific mounting brackets
• Anodized aluminum -AN adapter fittings and hose ends
• Stainless steel mounting hardware
• Radium Engineering PCV hose