Powerflex Front Lower Control Arm Rear Bushing Kit for R35 GTR (PFF46-702G)

Powerflex R35 GTR front lower control arm rear bushing kit includes CNC machined aluminum mounts to provide anti-lift and caster offset. Includes self-aligning bolts and stainless steel sleeves to combat failures of the original parts.

Also Available:
Powerflex recommends using the Camber Adjustable Front Control Arm Bushings with this bushing kit.

Vehicle Fitment:
2009+ Nissan R35 GT-R

Purchase Includes:
(2) Aluminum brackets fitted with polyurethane bushings
(2) Anodized aluminium sleeves
(2) Self-aligning bolts
(2) Washers
(2) PTFE Silicone Assembly Grease

Fitting Instructions:
1. Remove wishbones from the car and remove the original rear bush mounting bracket and bush from the wishbone.

2. Clean any dirt and corrosion from the end of the wishbone and press the anodized aluminum sleeve onto the end of the wishbone with the largest diameter of the sleeve being pressed onto the arm first. Apply pressure until it meets the end of the arm. Note: it is recommended to heat the anodized aluminum sleeve between 60-80°C before fitting to provide a good interference fit, allow to cool before fitting into the bushing

3. Apply the supplied PTFE / Silicone grease to the bore of the bush and insert the wishbone with sleeve fitted into the corresponding bush and bracket assembly with the smallest diameter of the sleeve fitting into the stepped section of the bush first. Note: the brackets and bushings are left and right handed and will only fit onto the car in the orientation shown in the diagram.

4. Re-fit the arm to the car and loosely fit the original long inner mounting bolt, followed by the smaller self-aligning bolt. Tension all hardware to manufacturers recommended torque settings.