DSX Paddle Wire Break Out for Motec V10 R8 Huracan
The DSX Tuning paddle wire break out kit aids in installing a Motec into your V10 R8 or Huracan by breaking out the upshift wires from the factory engine harness without the hassle of trying to tie into the wiring of the TCU connector.
Vehicle Fitment:
2010-2023 Audi R8 (V10)
2015-2024 Lamborghini Huracan
More Info:
This plugs into a 14-way connector underneath the factory slave ECU, and it includes the 7.6kΩ resistor needed in the R8 paddle wire. There is a two-way DTM connector to allow you to easily connect to the break out. Based on which vehicle you have, you will need to connect the E14 wire of the Motec harness to the vehicle-appropriate pin.
• Pin 1 - Huracan upshift
• Pin 2 - R8 upshift
Vehicle Fitment:
2010-2023 Audi R8 (V10)
2015-2024 Lamborghini Huracan
More Info:
This plugs into a 14-way connector underneath the factory slave ECU, and it includes the 7.6kΩ resistor needed in the R8 paddle wire. There is a two-way DTM connector to allow you to easily connect to the break out. Based on which vehicle you have, you will need to connect the E14 wire of the Motec harness to the vehicle-appropriate pin.
• Pin 1 - Huracan upshift
• Pin 2 - R8 upshift
Discounts:
We are sorry, discounts and codes are not available with DSX Tuning products.
We are sorry, discounts and codes are not available with DSX Tuning products.
See more DSX Tuning Products
 |
WARNING: Cancer and Reproductive Harm www.p65warnings.ca.gov |