CNC Series 412 Staging Brake
Fits these Applications:
The CNC Staging Brake was engineered to be spliced into the brake line between the brake master cylinder and the rear brakes. The staging brake should be mounted LEVEL next to the driver. It is recommended that steel brake line be used for the entire system. The steel line should be clean and the entire brake system must be free from dirt.
The staging brake comes equipped with fittings for either standard American 3/16" inverted flare brake line or 10mm metric thread-bubble flare brake line.
It is recommended that only DOT 3 or 4 brake fluid be used.
• Total-seal rubber boots
• All staging brakes come with a chrome handle
• Does not affect or hinder foot brakes
• Staging Brake splices in line between your master cylinder and calipers
• Your foot brake will always override the staging brake
Red and blue knobs are available here: CNC Staging Brake Knob
|As per California's Prop65 Laws, we are required to warn you that the products we sell will put you near a vehicle, which emits dangerous chemicals or worse. Please review the link below before purchase.|
Cancer and Reproductive Harm