Free shipping on orders over $200 to the continental USA

Torque Solution 3" (76mm) Turbo Inlet Hose (Recirc) - 02-07 Subaru WRX/04-20 STI 04-20

Torque Solution



Vehicle Fitment:
2002-2007 Subaru WRX
2004-2020 Subaru STI
2005-2009 Subaru Legacy GT
2004-2013 Subaru Forester XT 

Torque Solution Turbo Inlet Hose for the Subaru EJ Engines w/ 3" Inlet Turbo. This silicone inlet hose is much larger in size and smooths the air entering the turbo compared to the restrictive OEM corrugated inlet hose. This inlet hose is made from 4 ply high grade silicone and wire reinforced to prevent collapsing under high pressure. Torque Solutions includes 2 black anodized billet aluminum joiners to connect to either 2.75" or 3" intakes.

- Smooths Airflow Entering Turbo
- Increases Air Flow
- Eliminates failure prone corrugated rubber hose
- 4 Ply Silicone w/ Wire Reinforcement
- Includes Silicone Friendly Stainless Steel Hose Clamps
- Direct Fitment for Aftermarket 3" (76mm) Inlet Turbo's
- Recirculated BOV Inlet
- Limited Lifetime Warranty

- 3" Recirc Black Silicone Turbo Inlet Hose (1)
- 3" Billet Aluminum Coupler (for 3" Intakes) (1)
- 3" to 2.75" Billet Aluminum Reducer Coupler (for 2.75" Intakes) (1)
- 1.25" Aluminum BOV Recirc Adapter
- 70-90mm Silicone Safe Worm Gear Clamp (2)
- 30-45mm Silicone Safe Worm Gear Clamp (1)
- 3/8" 90 Degree Nylon Elbows (3)
- 1/2" to 3/8" 90 Degree Nylon Reducer Elbows (2)
- 1/2" to 3/8" Straight Nylon Reducer (2)
- 5/16" to 3/8" Straight Nylon Reducer (2)
- 1/2" Nylon T Fitting (1)
- 1/2" Fuel/PCV Hose (13")
- 1/8 NPT Stainless Plugs (4) (for DIY TGV Delete)
- Heavy Duty 10 Inch Zip Ties (5)

**Torque Solutions recommends either using their billet TGV deletes or using the supplied 1/8 NPT plugs to delete the factory TGV for clearance.

Important note: 
The Torque Solution inlet bypasses the PCV Diagnosis Port. You will need to perform a simple bypass.

  1. Locate PCV Diagnosis connector (grey or white depending on year), which located on the block next to throttle body.
  2. You will need to use a pair of needle nose pliers to remove the jumper pin inside the PCV Diagnosis connector. This pin should pull out easily only using slight pressure. Do not discard the jumper pin removed from the connector.
  3. Place the jumper pin into the female harness plug that was connected to PCV diagnosis connector. Use electrical tape to secure in place.


© All content is property of STM Tuned Inc
We price match!
If you find it cheaper, just give us a call!
(585) 226-8226

© All content is property of STM Tuned Inc

We price match!
If you find it cheaper, just give us a call!
(585) 226-8226

Customer Reviews

No reviews yet

Cancer and Reproductive Harm